We present the CLAMCLEAT® Junior Racing Clamp CL230
The lower roller on the Clamcleat® CL230 allows lines to be fed into the cleat from below. Ideal for routing a line through a surface. It can also be rigged directly onto a line for 1:1 or 2:1 leverage.
The CL230 is perfect for through-deck and through-mast applications. The illustrations show its use for Cunningham and kicker trim on an International 14 dinghy. It can also be used to tension sun awnings on yachts and motorboats; the dark gray CL230AN version complements carbon masts visually. The CL824 Riser Pad can be used to raise the CL230 so that the pulley sits above the surface, allowing a round hole to be drilled for the line.
The CL230 can also be mounted directly on a line. For easier release, we recommend using a PT230SSE. A CL834 handle can be mounted for trapeze adjustment with 4–5 mm lines. (A more affordable alternative to the PT230SSE is the PTLINK.)
Available in two versions:
-
CL230 with a silver stencil-printed coating, cost-effective and high-quality
-
CL230AN with a hard-anodized surface, particularly wear-resistant
A nylon version for lower loads is also available: CL203/S2.
To cut a smaller hole in the canopy, the CL230 can be raised using the CL824 Riser Pad.
Installing PT422 & PT23 insulators between the clamp and carbon tubes prevents galvanic corrosion. When combined with hard-anodized clamps, these are virtually invisible. If two insulator pads are mounted under the CL230, the pulley is also raised sufficiently to allow for drilling a round hole in the deck.
If the installation is done “free-hanging,” a PR230SSE Rope Guide makes it much easier to release the line.
A PTLINK also serves this purpose.
The CL253 is an aluminum clamp that can also be mounted on a line.
The CL211 Mk1 is a classic aluminum deck clamp, but without a lower pulley
SPECS
| Diameter | Length | Width | Height | Screw Size | Weight |
| 3–6 mm | 82 mm | 18 mm | 23 mm | M5 | 35 g |

















